Account
Checking…
Knight Division TacticalDoes KDT provide temporary power installation and electricians?
Temporary Power Installation & Electricians
Yes.
KDT provides temporary power installation and electricians: we plan the power system, set the generators and distribution, run the feeders, make building tie-ins and keep it all running, with electricians licensed as the job and jurisdiction require.
Typical configuration
- Scope
- Load calculation, one-line plan, install, inspection, operation, demob
- Systems
- 120/240 V 1-phase, 120/208 V and 277/480 V 3-phase temporary systems
- Code basis
- NEC Article 590 (temporary installations) and local amendments
- Protection
- GFCI on temporary receptacles, grounding electrodes, labeled circuits
- Checks
- Daily walk-down, breaker and connection checks, infrared scans on request
- Staffing
- Electricians and power technicians, on call 24/7 during the incident
Generators, spider boxes and cables are only half the job. Someone has to plan the system, connect it right and keep it safe for weeks. KDT does the whole power side of an incident: a load list from your camp layout, a one-line plan for generators, feeders and distribution, then the install, the inspection walk-through and the daily checks.
Our crews set and ground generators, lay camlock feeders and spider boxes, balance loads across phases, make sure outdoor receptacles are GFCI protected, wire trailers and tents, and make building tie-ins at docking stations or through transfer switches. Electrical work is done by electricians licensed as the job and jurisdiction require, and we coordinate with local inspectors where a permit applies.
Once it's live we keep it live: fuel schedules, run-hour service, checks on connections and breakers, and re-routing as the camp grows or shrinks. At demob we de-energize, pull and account for every cable.
Available as
- Full camp power design and installation
- Electrician support for generators you already have
- Building tie-ins and generator hookups
- Critical-facility power after a hurricane (shelters, lift stations, clinics)
- Power operations staffing only
- Demob, de-energizing and cable recovery
What's included
- Site walk and load list
- One-line power plan
- Installation of generators, feeders and distribution
- Inspection coordination where a permit applies
- 24/7 on-call electricians
- Fuel and maintenance coordination, and demob
Where it's used
- Base camps and ICPs
- Critical facilities after a hurricane
- Spill and hazmat staging and decon
- Remote contractor camps
- Temporary shelters
Questions, answered.
Does KDT provide temporary power installation and electricians?
Yes. We plan, install and run temporary power for your incident, from generators and distro to building tie-ins, with electricians licensed as the job and jurisdiction require.
Are your electricians licensed?
Electrical work is done by electricians licensed as the job and jurisdiction require. Where a permit or inspection applies, we coordinate it with the local authority.
Can you work with generators we already have?
Yes. We can install and run distribution off your generators, or add units where your capacity falls short.
What do you need to plan temporary power?
A camp layout or site map, the headcount, and the big loads: kitchen trailers, showers, laundry, HVAC, office trailers and comms. We build the load list from that.
Need it on your incident? Say the word.
Add it to your request with anything else you need, then send it all at once. We'll come back with what we can put where, and when.